氣體增壓泵利用壓縮空氣作為動力，不需要電源，無火花產生，適合煤礦、石油石化等需要防爆的場合。
The gas booster pump uses compressed air as power without power supply and spark generation. It is suitable for explosion-proof occasions such as coal mine, petroleum and petrochemical industry.
適用于大部分氣體增壓，可以對氬氣、二氧化碳、天然氣、氦氣、氫氣和氮氣增壓。
It is suitable for pressurization of most gases and can pressurize argon, carbon dioxide, natural gas, helium, hydrogen and nitrogen.
美國原裝進口HASKEL氣體增壓泵增壓壓力達269MPa。
The maximum boost pressure of Haskel gas booster pump imported from the United States is 269mpa.
高壓腔體與外界隔離，保證高壓腔內的氣體不被污染。
The high-pressure chamber is isolated from the outside to ensure that the gas in the high-pressure chamber is not polluted.
自帶冷卻，無油潤滑，氣動活塞環及其他氣動部件在工作狀態時不需要添加潤滑油，節省運行成本，防止油氣污染，滿足環保要求。
It has its own cooling and oil-free lubrication. The pneumatic piston ring and other pneumatic components do not need to add lubricating oil in the working state, so as to save the operation cost, prevent oil-gas pollution and meet the requirements of environmental protection.
當達到設定輸出壓力，大小活塞達到里的平衡，增壓泵停止工作，此時不再消耗能量，也沒有任何熱量產生，具有良好的壓力保持特性。當有壓力泄漏時，增壓泵自動補充壓力，頻繁啟動無任何影響。
When the set output pressure is reached, the balance between the large and small pistons is reached, and the booster pump stops working. At this time, no energy is consumed and no heat is generated. It has good pressure holding characteristics. When there is pressure leakage, the booster pump automatically replenishes pressure, and frequent startup has no impact.
多級泵組合可滿足客戶對不同壓力和不同流量的要求。
The multi-stage pump combination can meet the requirements of customers for different pressures and flows.
通常根據客戶工況要求非標定制
It is usually customized according to the customer's working conditions
氣體增壓系統典型應用
Typical application of gas pressurization system
閥門、管件、壓力容器等氣密性試驗
Air tightness test of valves, pipe fittings, pressure vessels, etc
氦氣檢漏及回收
Helium leak detection and recovery
高壓氣瓶充瓶和蓄能器充氣
High pressure cylinder and accumulator charging
潛水和消防呼吸氣瓶充氣
Diving and fire breathing cylinder inflation
禁油表和壓力傳感器的標定
Calibration of fuel gauge and pressure sensor
氣體輔助注塑和CO2發泡
Gas assisted injection molding and CO2 foaming
The content of this article is provided to you by the gas booster pump. We focus on customer needs, continuous development and provide customers with more services. For details, please refer to our website http://www.shuamiu.cn
